9
Windows Client Utility
Launch Application
After you successfully download the LiteShow Windows client, follow the steps below to start the
program.
1) Click the LiteShow shortcut.
2) Select the network you want to project over, and then the LiteShow module you wish to use.
3) If the LiteShow module is found, a Login Code dialog box will be displayed on your projector.
4) Enter the Login Code visible on the projector and click OK. Your computer screen should
begin displaying automatically. Note: The Login Code can be turned off by your administrator.
If no Login Code is displayed, then the Login Code is not required. Click OK to proceed.
To Next Page
Loading...
