InFocus X2 Service Manual

X2 Service Manual 16
Remove the Elevator Actuator and Spring
1 Remove the elevator shaft.
2 Slide the actuator and spring out of the elevator housing. Remove the spring from the actuator
once it is accessible.
3 Twist the actuator so that you can slide the it out of the bottom case.
Assembly Notes
♦ Before inserting the actuator into the elevator housing, slide the spring onto the end.
♦ When you install the elevator shaft, make sure that the grooves on the elevator shaft face the
lamp housing. Then depress the elevator actuator and insert the shaft into the elevator housing.
Make sure the teeth on the shaft engage the actuator.

InFocus X2 Specifications

General

Number of colors	16.78 million colors
Native aspect ratio	-
Projection distance	- m
Vertical scan range	50 - 85 Hz
Projection technology	DLP
Contrast ratio (typical)	2000:1
Screen size compatibility	- \
Projector native resolution	SVGA (800x600)
Focal length range	- mm
Number of built-in speakers	1
Lamp type	SHP
Lamp power	200 W
Service life of light source	3000 h
Full HD	No
Analog signal format system	NTSC, PAL
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Noise level	- dB
Placement	Desktop
Product type	Standard throw projector
Product color	Gray
Power consumption (standby)	- W
Harmonized System (HS) code	85286200

Weight and Dimensions

Weight	3100 g