EasyManuals Logo

InFocus X2 Service Manual

InFocus X2
67 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
X2 Service Manual 46
Power and Startup Problems
The projector communicates its status via an LED located on the keypad. When this status LED is green,
you know that the projector is working properly. When the status LED is solid red or flashing red, you
know there are lamp, power or startup problems. The frequency with which the status indicator blinks red
indicates one of several error codes. These error codes provide crucial information about projector
malfunctions.
Go to the next page to begin the power diagnosis sequence.
Below is a table that shows the meaning the various LED states.
NOTE We strongly suggest that you follow the entire power diagnosis sequence, which begins on the
next page.
LED Status
LED flashes green
The projector is starting up after the Power button was pressed, or the
projector is shutting down after the Power button was pressed.
LED is solid green
The projector is ready to light the lamp when the Power button is
pressed. Or the lamp is lit and the projector is operating properly.
LED flashes red once The lamp will not strike after five tries (2 1/2 minutes).
LED flashes red two times
The lamp has more than 3,000 hours of use. Requires replacement.
Projector shuts down.
LED flashes red three times Lamp failure. Projector shuts down.
LED is solid red Undiagnosed error. Projector shuts down.

Other manuals for InFocus X2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the InFocus X2 and is the answer not in the manual?

InFocus X2 Specifications

General IconGeneral
Number of colors16.78 million colors
Native aspect ratio-
Projection distance- m
Vertical scan range50 - 85 Hz
Projection technologyDLP
Contrast ratio (typical)2000:1
Screen size compatibility- \
Projector native resolutionSVGA (800x600)
Focal length range- mm
Number of built-in speakers1
Lamp typeSHP
Lamp power200 W
Service life of light source3000 h
Full HDNo
Analog signal format systemNTSC, PAL
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Noise level- dB
PlacementDesktop
Product typeStandard throw projector
Product colorGray
Power consumption (standby)- W
Harmonized System (HS) code85286200
Weight and Dimensions IconWeight and Dimensions
Weight3100 g

Related product manuals