Payment Terminals | Page 26 of 54
6.5 iCT250E
iCT250E is supplied with a power supply cable and connected to the internet of the store via Ethernet cable.
It can also be integrated with an ECR system through serial, IP Ethernet or USB connection.
6.5.1 Ethernet / Broadband
To connect the terminal to a power supply and internet, please locate the following components:
NB: The terminal must be switched o when connecting the Ethernet cable.
6.5.2 MagicBox
When requested by a merchant, the iCT250E model can also be integrated with an ECR via serial or USB connection. Magic-
Box can be used when iCT250E is used standalone or integrated with an ECR system. In this arrangement, a MagicBox comes
already connected to four ports at the back of the payment terminal. It means that the merchant is only required to connect
a single network cable (RJ45) from the MagicBox to e.g. the ECR.
MagicBox can be used when iCT250 E must be integrated with an ECR system. At one end of the MagicBox cable there are
four dierent cables which must be connected to the payment terminal:
Open the cable cover by
pressing the clips upwards.
Lift the cover in the direc-
tion of the arrow.
When the cover has been
removed, connect the ter-
minal power cable (1) and
Ethernet cable (2).
To close the cover again
replace the top part, rst
ensuring that the cover clips
are in place on the terminal.
Then press the cover down
towards the back of the ter-
minal.
1. Analogue line.
2. Power supply.
3. Integration with ECR system.
4. Ethernet connection.
To Next Page
Loading...
