Payment Terminals | Page 28 of 54
6.7 iWL250G
iWL250G uses GPRS or 3G for communication. It is delivered with a Base Station and power supply cable.
6.7.1 Base Station
The terminal is charged in the accompanying Base Station. Charging may also be done on-the-go via the side micro-USB
port. To install and charge an iWL250G, do as follows:
Connect the power cable to
the Base Station.
Place the terminal on the
Base Station.
The terminal will connect
and is then ready for use.
The new terminal comes
with a battery that has been
minimally charged. The ter-
minal must be charged to
perform to the full.
6.7.2 SIM Card
Nets SIM cards are typically used for Move/3500 (4G/Wi-Fi) and are bundled with the delivery. This applies to rental terminals
only, not purchased terminals. There is an extra charge for purchased terminals. However, customers are also free to use
their own SIMs. Nets SIM cards enable roaming between the national networks that are most prominent in the area of the
merchant site, giving Nets SIM cards a clear advantage over other SIM cards.
6.8 iPP350
Connecting the Base Station to a Network
For an iWL250B to work, it must be associated with a Base Station within range. To change which Base Station iWL250B is con-
nected to, do as follows:
1. Press the button at the far left under the screen.
2. Select 0 – Telium manager.
3. Enter code 4302+OK.
4. Select Initialization > Hardware > Cradle setup > Association.
5. Now you can choose to add a new Base Station, select a Base Station, or delete a Base Station
Insert the SIM card under the ap label-
led “SIM”.
Open the backside cover by pressing the
clips downwards.
To Next Page
Loading...
