Ingenico iPP350 - Z-Total; Copy of Last Z-Total

Payment Terminals | Page 38 of 54
11.3 Z-Total
Z-total is a report that shows the accumulated sales performed on the terminal since the last Z-total was printed. The stored
gures are reset when a Z-Total is printed.
NB: Performing Z-Total does not perform reconciliation. Printout of a Z-Total will not reconcile the terminal.
Press MENU.
Main menu
5 Copy menu
6 Reconciliation
7 Operator menu
Press 7
or scroll down to Operator Menu and press OK.
Operator menu
1 Reports
2 Issuers
3 Term status
Press OK for Reports.
Reports
1 Trans. list
2 X-Total
3 Z-Total
Press 2
or scroll down to X-Total and press OK.
Print Pending Wait for report.
11.4 Copy of Last Z-Total
This function is used to extract a copy of the most recent Z-Total.
NB: Performing Z-Total does not perform reconciliation. Printout of a Z-Total will not reconcile the terminal.
Press MENU.
Main menu
3 Card services
4 Optional Func
5 Copy menu
Press 5
or scroll down to Copy menu and press OK.
Copy menu
1 Last receipt
2 Last reconc.
3 Last Z-Total
Press 3
or scroll down to Last Z-Total and press OK.
Print Pending
Wait for copy.