InHand CR202 - 3.8 APPLICATION; 3.8.1 SMBC

19
configuration take effort.
3.2.5 WLAN Client (AP Mode)
When working in AP mode, CR202 WLAN will provide network access point for other wireless
network devices. Please sure that CR202 has already connect to Internet via WAN or cellular.
Click the “Network>>WLAN” menu in the navigation tree to enter the “WLAN" interface.
Table 3-2-5 Parameters of WLAN Access Port
WLAN
Function description: Support Wi-Fi function and provide wireless LAN access on site and
identity authentication of wireless user.
Parameters
Description
Default
SSID broadcast
After turning on, clients can search the WLAN via SSID
name
Enable
Mode
Six type for options: 802. 11g/n, 802. 11g, 802. 11n, 802.
11b, 802. 11b/g , 802. 11b/g/n
802.11b/g/n
Channel
Select the channel
11
SSID
SSID name defined by user
inhand
Auth Mode
Support OPEN, SHARED, WEPAUTO, WPA-PSK, WPA,
WPA2-PSK, WPA2, WPA/WPA2, WPAPSK/WPA2PSK
OPEN
Encryption
Method
Select encryption method of AP
NONE
Bandwidth
Support 20MHz and 40MHz
20MHz
Enable WDS
Click to enable WDS, router will connect other AP to
extend wireless coverage
Disable
Default Route
Click to enable Route
Disable
Bridged SSID
Set bridged SSID of other AP, support to click “Scan”
button to connect to available AP in network
None
Bridged BSSID
Set bridged BSSID of AP
None
Auth Mode
Open type, shared type, WPA-PSK, WPA2-PSK
Open type
Encryption
Method
Support NONE, WEP
None
3.2.6 WLAN Client (STA Mode)
When working in STA mode, the router can access the Internet by connecting to other AP.
Click the “Network>>WLAN Client” menu in the navigation tree to enter the “WLAN” interface.
Select “Client” for the interface type and configure relevant parameters. (At this moment, the