InHand CR202 - Sms; Traffic Manager

2 6
3.3.6 SMS
SMS permits message-based reboot and manual dialing. Configure Permit to Phone Number and
click <Apply and Save>. After that you can send “reboot” command to restart the device or send
custom connection or disconnection command to redial or disconnect the device.
From navigation tree, select "Service>>SMS" menu, then enter “SMS” page.
Table 3-3-6 SMS Parameters
Short message
Function description: Configuration SMS function to manage the router in the form of SMS.
Parameters
Description
Default
Enable
Click to enable SMS function
Disable
Status Query
Define the English query instruction to inquire current
working status of the router.
N/A
Reboot
Define the English query instruction to reboot the router.
N/A
SMS Access Control
Default Policy
Select the manner of access processing.
Accept
Phone Number
Fill in mobile number
N/A
Action
Accept or block
Accept
Description
Describe SMS control.
3.3.7 Traffic Manager
This function is mainly used to count data traffic in cellular interface. If the threshold is 0, router
will only count and the rules will not take effort. This function requires enabling NTP function.
Choose Services >> Traffic Manager to go to the "Traffic Manager" page.
Table 3-3-7 Traffic Manager
Traffic Manager
Function: Monitor and manage the traffic use of the router.
Parameters
Description
Default
Enable
Click to enable the traffic manager function.
Disable
Start Day
The day to start counting data traffic every month
1
Monthly
Threshold
Data traffic threshold every month
0MB
When Over
Monthly
Threshold
Operation when data traffic used within a month reaches the
threshold:
Only Reporting,
Block Except Management(will not influence DM and
Only
Reporting