28
3.4.1 Basic
From the navigation tree, select Firewall >> Basic, then enter basic setup page.
Table 3-4-1 Firewall - Basic Parameters
Function description: Set basic firewall rules.
Block Anonymous WAN Requests
(ping)
Select to filter WAN detection packet like
PING detection
Select to filter multicast function
Select to defend DoS attack
3.4.2 Filtering
Filter the network data by customize rules to allow or prohibit the specified data flow forwarded
by router.
To enable Access Control from the navigation tree, select Firewall >> Filtering, then enter
“Filtering” page.
Table 3-4-2 Filtering Parameters
Function description: Control the protocol, source/destination address and source/destination
port passing through network packet of the router to provide a safe intranet.
Check to enable filtering.
Set source address of access control
Set source port of access control
Set destination port of access control
Click to enable log and the log about access control will be
recorded in the system.
Convenient for recording parameters of access control
To Next Page
Loading...