InHand CR202 - Alarm Settings; User Experience Plan; Firewall

27
management requirement),
Shutdown Interface
Last 24-Hours
Threshold
Data traffic threshold in last 24 Hours
0KB
When Over
24-Hours
Threshold
Operation when data traffic used within 24 hours reaches the
threshold
Only
Reporting
Advance
Custom statistics and operations last several hours
Disable
3.3.8 Alarm Settings
When an abnormality occurs, router will report alarm according to the settings. Currently router
supports sending alarm in following situations: System Service Fault, Memory Low, WAN/LAN1
Link-Up/Down, LAN2 Link-Up/Down, Cellular Up/Down, Traffic Alarm, Traffic Disconnect
Alarm, SIM/UIM Card Switch, Active Link Switch, SIM/UIM Card Fault, Signal Quality Fault.
In the Alarm Manager interface, you can perform the following operations:
 Select alarm types in the "Alarm Input" area.
 Set the alarm notification method of the console in the "Alarm Output" area.
Choose Services >> Alarm Manager to go to the "Alarm Manager" page.
3.3.9 User Experience Plan
InHand Networks’ User Experience Program is designed to improve the product user experience
and customer service quality.
User can disable or enable User Experience Plan in “Services >> User Experience Plan”
3.4 FIREWALL
The firewall function of the router implements corresponding control to data flow at entry
direction (from Internet to LAN) and exit direction (from LAN to Internet) according to the
content features of message (such as: protocol style, source/destination IP address, etc. ) and
ensures safe operation of router and host in local area network.