InHand CR202 - 3.9 STATUS; 3.9.1 System; 3.9.2 Modem; 3.9.3 Traffic Statistics

20
cellular interface in the "Network>>Cellular" should be closed.)
The SSID scan function is enabled only when Client is selected as WLAN interface. Click “Scan”
button to get all available AP and status, select AP and configure corresponding parameter to
connect. After configure WLAN Client, please configure access type in “Network>>WAN(STA)”.
Table 3-2-6 Parameters of WLAN Client
WLAN Client
Function description: Support Wi-Fi function and access to wireless LAN as client.
Parameters
Description
Default
Mode
Support multiple modes including
802.11b/g/n
802.11b/g/n
SSID
Name of the SSID to be connected
inhand
Auth Mode
Keep consistent with the access point to be
connected
Open type
Encryption Method
Keep consistent with the access point to be
connected
NONE
3.2.7 IP Passthrough
IP penetration function distributes the address obtained by WAN port to the device at the lower
end of LAN port. When external access to the router downstream devices the router transmits data
to the downstream device. Click "Network >>IP Passthrough" menu, then enter “IP Passthrough”
page.
Table 3-2-7 IP Passthrough Parameters
IP Passthrough
Function description: LAN port device to obtain WAN port address, used for external access to
router downstream devices.
Parameters
Description
Default
IP Passthrough
Enable IP Passthrough
Disable
IP Passthrough Mode
Select work mode（DHCP Dynamic/DHCP fix MAC)
DHCP
Dynamic
Fix MAC Address
Set fix MAC address if in DHCP fix MAC mode
00:00:00:00:0
0:00