create new username, i.e. only this username can be used in logins.
3.1.4 System Log
A remote log server can be set through “System Log”, and all system log will be uploaded to the
remote log server through Internet. This requires remote log software, in such as Kiwi Syslog
Daemon, on remote log server.
Kiwi Syslog Daemon is a free log server software for Windows, It can receive, record and display
logs from host (such as router, exchange board and Unix host). After downloading and installing
Kiwi Syslog Daemon, it must be configured through the menus “File >> Setup >> Input >> UDP.
From the navigation tree, select System >> System Log, then enter “System Log” page.
Table 3-1-4 Parameters of System Log
Function description: Configure IP address and port number of remote log server which will
record router log.
Log server address and
port (UDP)
Set address and port of remote log server
3.1.5 Configuration Management
Here you can back up the configuration parameters, import the desired parameters backup and
reset the router.
From the navigation tree, select “System >> Config Management”, then enter the “Config
Management” page.
Table 3-1-5 Parameters of Configuration Management
Function description: Set parameters of configuration management.
Choose the configuration file
Import configuration file to router
Backup configuration file to host
Restore default
configuration
Select to restore default configuration (effective after
rebooting)
To Next Page
Loading...