InHand CR202 - 3.6 TOOLS; 3.6.1 PING; 3.6.2 Traceroute; 3.6.3 Link Speed Test

18
ICMP Detection Timeout
Set ICMP detection timeout
20 s
ICMP Detection Retries
Set ICMP detection max. retries
3
3.2.3 LAN
Click “Network >> LAN” to configure LAN interface of router and other devices can access to
Internet via Ethernet cable in LAN.
Table 3-2-3 LAN Parameters
LAN – Static IP
Function description: Devices in LAN use static IP to connect to network.
Parameters
Description
Default
MAC Address
MAC Address of router’s LAN
gateway
Router’s LAN MAC address
IP Address
IP Address of router’s LAN gateway
192.168.2.1
Netmask
Subnet mask of LAN gateway
255.255.255.0
MTU
Max. transmission unit, default/manual
settings
default (1500)
LAN Mode
Set transport mode in LAN interface
Auto Negotiation
Multi-IP Settings (at most 8 additional IP addresses can be set)
IP Address
Set additional IP address of LAN
N/A
Subnet mask
Set subnet mask
N/A
Description
For recording significance of
additional IP address
N/A
LAN Port Enable
port1/port2
Enable corresponding LAN port
Enable
GARP
Enable
Router will send ARP broadcast to
LAN devices automatically
Disable
Broadcast Count
Set ARP broadcast times
5
Broadcast Timeout
Set ARP broadcast timeout time
10
3.2.4 Switch WLAN Mode
CR202 supports two types of WLAN mode: AP and STA
Click the “Network>>Switch WLAN Mode” menu in the navigation tree to set WLAN mode of
the router. After change and save the configuration, please reboot the device to make the