InHand CR202 - Traceroute; Link Speed Test; Tcpdump; Application

34
3.6.2 Traceroute
To perform traceroute, select "Tools>>Traceroute" menu in the navigation tree.
Table 3-6-2 Traceroute Parameters
Traceroute
Function description: Applied for network routing failures detection.
Parameters
Description
Default
Host
Address of the destination host which to
be detected is required.
N/A
Maximum Hops
Set the max. hops for traceroute
20
Timeout
Set the timeout of traceroute
3 s
Protocol
ICMP/UDP
UDP
Expert Option
Advanced parameter for traceroute is
available.
N/A
3.6.3 Link Speed Test
Enter the navigation tree, select “Tools>>Link Speed Test”, then enter the “Link Speed Test” page.
Select a file locally and click upload/download, then check the network speed in log.
3.6.4 TCPDUMP
Enter the navigation tree, select “Tools>>TCPDUMP”, then enter the TCP dump page.
Table 3-6-4 TCPDUMP Parameters
TCPDUMP
Function description: Capture the packet transferring through specific interface
Parameters
Description
Default
Interface
Select the interface to capture the packet
ANY
Capture number
Stop TCP dump after capture this
number of packets
10
Expert Option
Advanced parameter for TCPDUMP
N/A
3.8 APPLICATION
Customize application for specific customer.