Innovative NV10 - NV10 Belt Changing

Copyright Innovative Technology Ltd 2008 GA333-5
.2 BELT CHANGING
• With the NV10 note paths exposed (see figure 11) place the unit on a clean
lower cover plate by lifting up the retention catch and carefully
inwards then slide each belt off the drive unit
em over the drive unit body legs, smallest
er cover plate into the locating slots (2 each side) pushing
Figure 12 – NV10 Belt Access
9
dry surface.
• Remove the
sliding it back (see figure 12).
• Push the 2 belt tension springs
body, smallest wheels first.
• Replace the belts by fitting th
wheels first.
• Place the low
forward and down, the plate will ‘’click’’ confirming correct insertion.
• Connect the upper and lower note path back together.
NV10 Operations Manual 28
NV10 Operations Manual 26
Belts
Lower Cover Plate
Belt Tension
Springs
Retention Catch
Drive Unit
Locating
Body
Slots