Copyright Innovative Technology Ltd 2008 GA333-5
4.1 DIPSWITCH SETTINGS
e four DIPswitches can be set to a combination of either up or down depending on
particular NV10.
e interface. Details of the
red in the interfaces’ description in this manual.
ble 3 - Switch 3 and achine Interface Select
The details of the p terface protocols
section of this manual.
ds on the firmware that is used in the NV10, the firmware
dard is ccTalk (unless specified by order). The table below shows all the
formation on each of these interfaces can be found in the ‘machine interfaces protocol
ection’ of this manual.
4.2 LED STATUS CODES
he three status LED’s are located to the right of the DIPswitches on the top of the unit and
f status signals.
Th
the configuration required for the
Switch 1 – Spare
witch 1 currently has no function and is reserved for future use. S
Switch 2 – Extended Options
his switch is used to modify the behaviour of the selected machinT
function of this switch are cove
Switches 3 and 4 – Machine Interface protocol selection
hese switches are used to select the machine interface to be used. The NV10 supports T
numerous interfaces, as shown below, (see table 1).
Ta 4 M ion
arallel, pulse, and SSP can be found in the machine in
Special Modes
he special interface depenT
shipped as stan
options that can be downloaded by the user:
In
s
T
are used to indicate a variety o
The red status is used to indicate system problems, while the green status indicates system
ealth; these are described below in table 2. h
Interface Switch 3
To Next Page
Loading...