Selection of Options
‑113‑
Figure 4‑19 Magnetic buckle dimensions
Table 4–16 Magnetic buckle dimensions
Magnetic Buckle Model
Overall Dimensions (Length x Outer Diameter x Inner
Diameter) (mm)
74271225 32.8 × 28 × 13
4.1.7 Motor
To effectively protect motors with different loads, the overload protection gain of
motors must be set according to their overload capacity. Generally, the default value
of protection gain is used. However, it can be changed according to the actual motor
heating conditions when any of the following conditions occurs:
● The motor works in an environment of high temperature.
● The motor keeps cyclic running with short single cycle and frequent acceleration/
deceleration.
The motor overload protection curve is an inverse time lag curve, as shown in the
following figure.
To Next Page
Loading...
