Standards Compliance
‑126‑
● This product conforms to the Low Voltage Directive (LVD), Electromagnetic
Compatibility (EMC), and Restriction of Hazardous Substances (RoHS) Command,
and is therefore marked with CE.
● The machinery and devices equipped with this product must also meet CE
requirements when sold in Europe.
● The integrator who integrates this product with other devices has the
responsibility of ensuring compliance with CE standards when the CE mark is
labeled on the final device.
7.2.2 Conditions for Compliance with the EMC Directive
● This product satisfies the European EMC directive 2014/30/EU and the EN 61800‑3.
It is applied to both the first environment and the second environment.
When applied in the first environment, this product may generate radio interference. Be‑
sides the CE compliance described in this chapter, take measures to avoid the radio inter‑
ference if required.
● To satisfy the EMC directive and standard, install the EMC filter on the input side of
the product, connect a recommended shielded cable on the output side, ground
the filter reliably, and connect the shielding layer of output cable in 360°.
The integrator of the system installed with this product is responsible for compliance of the
system with the European EMC directive and EN IEC 61800‑3 according to the system appli‑
cation environment.
EMC Specifications
Follow the product requirements during installation. This product meets the
requirements of EN IEC 61800‑3 standard. See the following table for the maximum
allowable motor cable length for conducted and radiated interference.
To Next Page
Loading...
