Inovance Monarch NICE-L-C-4037F - Page 176

5 System Commissioning
-
175
-
NOTE
◆
Ensure that shaft auto-tuning is completed successfully, and the elevator
runs properly at normal speed.
◆
After you set Fr-00 to 1, the elevator shields hall calls, automatically runs to
󶍿
◆
󶙓󶙓
Positive value: up arrow + value, negative value: down arrow + value,
adjustment range: ±30 mm
◆
󶍿
◆
󶍿
data once. Otherwise, you cannot register the car call.
3 Leveling accuracy adjustment guidelines
■
󶍿󶍾
same in up and down directions and the car is not leveled with the hall sill, make
󶍿
■
󶍿󶍾󶍽
in up and down directions, make adjustment by setting both F4-00 and group Fr
󶍾
󶍿
stop positions in down and up direction are respectively a and b, and perform the
operation according to the following table.
Type Diagram Calculation
Adjustment
Operation
Under-
leveling
a
b
Up
Down
 (F4-00) + H
Over-
leveling
a
b
Up
Down
 
󶍿
Pay attentions to the following precautions:
Prevent over-adjustment in group Fr parameters when the leveling deviation is too
large.
Assume that when the car arrives at the leveling zone, the distance between the edge
of the leveling sensor and the edge of the leveling plate is A, and the height deviation