Inovance Monarch NICE-L-C-4037F - Page 218

6 Parameter Description
-
217
-
F6-40 Program control selection 1
Bit Function Description Default
Bit1 Soft limit function
When the up slow-down and down leveling
signals are active and the up leveling signal is
inactive, the system considers that the up limit is
performed.
It is the same for the down limit signal.
0
Bit2
JP16 input used as
back door selection
(button)
JP16 is used for the input of the back door open
signal. This function is enabled if FC-04 is set to 2.
When JP16 has input, the elevator opens only the
back door. When IP16 has no input, the elevator
opens only the front door.
0
Bit3
JP16 input used as the
back door open signal
JP16 is used for the input of the back door open
signal.
0
Bit4
Opening only one
door of opposite doors
under manual control
This function is enabled only in the opposite door
control modes 3 and 4. In this case, only one door
opens each time while the other door must stay in
the door close limit state.
In group Fd, the extended input includes "Single/
Double door selection". If this input is active in the
opposite door control mode 3, both doors open if
there is a car call.
0
Bit5 Timed elevator lock
F6-38/F6-39 is valid only when this function is
enabled.
0
Bit6 Manual door
This function is used for the elevator with manual
door.
0
Bit7 Reserved - -
Bit8 Reserved - -
Bit9
󶍿
number clear
The system clears all the current car calls every
time the elevator changes the direction by default.
When this function is enabled, the function of
󶍿
0
Bit10
Displaying next
󶍿
󶍿
elevator running.
0
Bit11
Responding to car calls
󶍾
The system responds to hall calls only after
executing all car calls.
0
Bit12
Car call assisted
command in single
door used as disability
function
You can set the auxiliary command terminal (CN8)
on the CTB for input of the disability calls.
0: Consistent with CN7 for the single door, and
back door for the double door
1: CN8 calls are the disability calls
0
Bit13
Folding command
used as disability
function and back
door function
It is valid only when the function of Bit14 is
enabled.
1: Disability 0: Back door
0