6 Parameter Description
-
218
-
F6-40 Program control selection 1
Bit Function Description Default
Bit14
Car call command
folding
Car call command folding:
A. Function disabled: CN7 is used for front door
calls or ordinary calls, and CN8 is used for back
door calls or disability calls.
B. Function enabled: For CN7 and CN8, inputs 1 to
16 are used for front door calls or ordinary calls,
and inputs 17 to 32 are used for back door calls or
disability calls.
0
Bit15
JP20 used for
switchover to back
door
(switch)
JP20 is used for input of switchover between the
front door and the back door.
0
F6-41 Program control selection 2
Bit Function Description Default
Bit0 Reserved - -
Bit1 Reserved - -
Bit2
Inspection to stop
due to slow-down 1
During inspection running, if the slow-down 1 acts,
the system decelerates to stop.
0
Bit3 Reserved - -
Bit4
Buzzer tweet during
door open delay
The buzzer will tweet when the door open delay time
set in Fb-14 is reached.
0
Bit5 Reserved - -
Bit6
Canceling door
open delay
Door open delay is canceled when the door open
delay button is pressed again.
0
Bit7 Reserved - -
Bit8
Elevator lock at
door open
In the elevator lock state, the elevator keeps the door
0
Bit9
Display available at
elevator lock
In the elevator lock state, hall calls are displayed
normally.
0
Bit10
Elevator lock in the
attendant state
The elevator is locked properly in the attendant state. 0
Bit11 Blinking at arrival
The car display blinks when the elevator arrives at a
0
Bit12
Door re-open
during door open
delay
The door re-opens if the door open delay input is
active during door close.
0
Bit13
Door re-open after
car call of the
valid during door close.
0
To Next Page
Loading...