Inovance SV820N Series - 4.5 User Password; 4.5.1 Setting User Password; 4.5.2 Canceling User Password

- 83 -
4 Operation Panel
4
4.4 Parameter Setting
Parametersettingcanbeperformedonthekeypadofservodrive.Fordetailsontheparameters,referto
Chapter8.The following gureshowsthekeypad operation of switchingthepositioncontrol mode tothe
speed control mode after the power is on.
Figure 4-5 Diagramforkeypadoperationofparametersetting
Parameter group
display
Offset display in
the group
Parameter
display
Parameter setting
completed
Servo state display
Servo ready
MODE
MODE
MODE
MODE
SET
SET
SET
● MODE:Switchthedisplaymodeandreturntotheupper-levelmenu.
●
/ :Increaseordecreasethevalueofthecurrentblinkingdigit.
●
:Changethecurrentblinkingdigit.
● SET:Storethecurrentsettingvalueorswitchtothenext-levelmenu.
Whenthe"Done"screenisdisplayedafterparametersettingiscompleted,presstheMODEkeytoreturnto
the parameter group display (the "H02-00" screen).