EasyManuals Logo

Insignia NS-42E859A11 User Manual

Insignia NS-42E859A11
123 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
4
www.insigniaproducts.com
Safety Information NS-32E859A11/NS-42E859A11
Power lines
An outside antenna system should not be located in the
vicinity of overhead power lines or other electric light or
power circuits, or where it can fall into such power lines or
circuits. When installing an outside antenna system, extreme
care should be taken to keep from touching such power lines
or circuits as contact with them might be fatal.
Handling the LCD panel
Your TVs screen is made of glass. Do not drop your TV or hit,
jolt, or press hard against the LCD panel. If the screen breaks,
be careful of broken glass.
If the LCD panel is broken, make absolutely sure that you do
not touch the liquid in the panel. This may cause skin
inflammation.
If the liquid gets in your mouth, immediately gargle, rinse,
and consult with your doctor. Also, if the liquid gets in your
eyes or touches your skin, consult with your doctor after
rinsing for at least 15 minutes or longer in clean water.
Replacement parts
When replacement parts are required, make sure that the
service technician uses replacement parts specified by the
manufacturer that have the same characteristics as the original
part. Unauthorized substitutions may result in fire, electric
shock, personal injury, or other hazards.
Safety check
After completing any service or repair to this device, ask the
service technician to perform routine safety checks to
determine that your TV is in correct operating condition.
Power source
Operate your TV only from the type of power source indicated
on the marking label. If you are not sure of the type of power
supplied to your home, consult an electrician or your local
power company.
Cautions
Damage requiring service
Unplug this TV from the power outlet and refer servicing to
qualified service personnel under the following conditions:
When the power supply cord or plug is damaged or frayed.
If liquid has been spilled or objects have fallen into your TV.
If your TV has been exposed to rain or water.
If your TV does not operate normally by following the
operating instructions. Adjust only those controls that are
covered by the operating instructions because incorrect
adjustment of other controls may result in damage and will
often require extensive work by a qualified technician to
restore your TV to its normal operation.
If your TV has been dropped or damaged in any way.
When your TV exhibits a distinct change in performance.
Outdoor antenna grounding
If an outside antenna or cable system is connected to your TV,
make sure that the antenna or cable system is grounded to
provide some protection against voltage surges and built-up
static charges. Article 810 of the National Electrical Code,
ANSI/NFPA No. 70, provides information with respect to
correct grounding of the mast and supporting structure,
grounding of the lead-in wire to an antenna discharge unit,
size of grounding conductors, location of the
antenna-discharge unit, connection to grounding electrodes,
and requirements for the grounding electrode.
2
1
3
4
5
6
7
Antenna lead-in wire
Grounding clamp
Antenna discharge unit
Grounding conductors
Ground clamps
Power service grounding electrode system
Electric service equipment
1
2
3
4
5
6
7

Table of Contents

Other manuals for Insignia NS-42E859A11

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Insignia NS-42E859A11 and is the answer not in the manual?

Insignia NS-42E859A11 Specifications

General IconGeneral
Display diagonal42 \
Display brightness450 cd/m²
Supported video modes1080p
Contrast ratio (dynamic)12000:1
Screen format adjustments16:9
Supported graphics resolutions1920 x 1080 (HD 1080)
3DNo
Backlight-
Headphone connectivity3.5 mm
HDMI ports quantity4
DVI-D ports quantity1
DVI-I ports quantity0
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Compatible memory cardsNot supported
Product colorBlack
Panel mounting interface200 x 200 mm
RMS rated power- W
Number of speakers3
Power consumption (standby)1 W
Power consumption (typical)115 W
Remote control typeStandard
Weight and Dimensions IconWeight and Dimensions
Depth (with stand)279.4000 mm
Weight (with stand)17780.8209 g
Depth (without stand)50.8000 mm
Width (without stand)990.6000 mm
Height (without stand)609.6000 mm
Weight (without stand)14605.6743 g

Related product manuals