2-3
Site Requirements
Product Support: www.instron.com
responsible for insurance cover while the testing system is in the factory up until it reaches
the loading dock for shipping.
Installation
When the site location is prepared and the frame and its components have been moved to the
final operating location (refer to Chapter 3 “Lifting and Handling”), Instron is
responsible for the complete installation of the load frame, its components and any
additional accessories that may have been purchased.
The customer must not make any attempt to install the load frame without an Instron service
representative present.
Initial Operation
Once the installation is complete, Instron performs an initial operation of the load frame and
a calibration check to ensure that it is working properly.
The service representative also performs a required on-site training program. The required
on-site training takes approximately one day to complete, and is designed to accommodate
up to three individuals.
Contact Instron’s Professional Services department for more information on this training
(refer to “Product Support” on page 1-8). Additional training is available through
Instron’s training center.
Documentation
Instron provides all the documentation required to operate the system, including manuals for
the load frame and any required online help systems for software applications.
Additional copies of manuals are available and can be ordered through Instron’s Sales
department.
Site Requirements
Proper site preparation is imperative so that the testing system operates in accordance with
its specifications and provides accurate test results.
To Next Page
Loading...
Need help?
General
