Instruo arbhar - Spray and Gate Output

16
Spray: The Spray parameter controls a random deviation of the grain
start position. The amount and location of start position deviation is
shown on the Granular Stream display.
• Spray functionality will deviate from the current Scan position to the
right of the layer. The Spray parameter is biased towards the current
Scan position, in order to create a sense of moving through the
recording if the Scan position is changed.
• The start position is set at the start of each grain and remains
unchanged for the duration of the grain.
• If the value of the Spray parameter is greater than the duration
available from the Scan position to the end of the layer, the Spray
parameter will extend to include the time in front of the set
Scan position.
• If the Spray parameter is set to its maximum value, the start position
for the grains will be completely random positions within the
entire layer.
Gate Output: The Gate Output generates gate signals. The generation
of the gate signals are dependent on the selected Onset Control Mode
(See the Onset Control Modes section for more information).
• Output range: +5V.
• Duty cycle: 12ms.