Instruo arbhar - Length and Scan Parameters

15
• Grains from the Continuous Granular Engine are indicated by
white LED illumination.
• Grains from the Strike Granular Engine are indicated by amber
LED illumination.
• Both Grain Direction Indicators will illuminate amber when arbhar
is set to Wavetable Mode (See the Wavetable Mode section for
more information).
Length: The Length parameter sets the duration of each grain ranging
from ~40ms - 3s. This parameter is crucial to the granular texture. Grain
length is shown on the Granular Stream display.
• Length values are applied at the beginning of each grain and
remain unchanged for the duration of the grain.
• The rate at which grains are generated is set by both the Intensity
and Length parameters.
Length CV Input: The Length CV Input is a bipolar control voltage input
for the Length parameter.
• Control voltage is summed with the knob position.
• Input range: 10V. e.g. a voltage difference of 10V is needed to
control from the minimum to maximum knob position. If the knob is at
its centre position, the accepted input range is -/+5V.
Scan: The Scan parameter sets the point of grain generation within the
layer. The position of the Scan parameter is shown on the Granular
Stream display.
• The start position is set at the start of each grain and remains
unchanged for the duration of the grain.
Scan CV Input: The Scan CV Input is a bipolar control voltage input for
the Scan parameter.
• Input range: -/+5V.