To Next PageTo Next Page
Need help?Do you have a question about the Intec Controls MSR PolyGard 2 DGC6 and is the answer not in the manual?
General| Brand | Intec Controls |
|---|---|
| Model | MSR PolyGard 2 DGC6 |
| Category | Controller |
| Language | English |
Displays gas concentrations and monitors controller status in standard operation.
Activates alarm relay and LED when gas concentration exceeds programmed threshold.
Delays measurements for service/modification, suppressing alarm evaluation.
Explains the purpose of each button and status indicator light on the device.
Guides users through modifying configuration settings and desired setpoints.
Details the different access levels and passwords for system configuration and operation.
Covers recording, acknowledging, and viewing system and sensor faults.
Displays active alarms in text format, ordered by occurrence.
Shows the current status of alarm and signal relays.
Displays measured values with gas type, unit, current, and average values.
Provides details on system and sensor maintenance schedules and messages.
Configures and manages the recording of data to a USB device.
Allows modification of non-password-protected display and system settings.
Enables reading and changing of measuring point parameters and alarm relay assignments.
Defines the system's purpose for monitoring and controlling gas levels.
Outlines requirements for proper installation, compliance with regulations, and safety.
Recommends regular checks, calibration, and part replacement for optimal efficiency.
Details the two-year warranty against defects in material or workmanship.
