Intec Controls MSR PolyGard 2 DGC6 User Manual

INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com
Specifications subject to change without notice. | GAGC06_E_0516 | USA 200303 | Page 8 of 41
DGC6 – UserManual
4 Menu Overview
The Gas Controller DGC6 is operated via a logical and intuitive menu structure. The operating menu contains the
following levels:
● Starting menu with date and time if no SP (sensor point) is dened, otherwise a scrolling display of the gas
concentrations of all active sensors in 5-second intervals. If alarms are active, only the values of
the sensors currently in alarm status are displayed.
● Main menu
● Submenu 1 and 3
INTEC
13.06.13 1:45am
Display of gas
concentration
Power On Time
Power On TimeMain menu
After 30 sec.
Starting menu
or
Controller information and general setup
See from 4.7
Reading and change of the data logger parameters
See from 4.6
Information about the connected devices
See from 4.5
Display of measuring values
See from 4.4
Display of the signal relays status
Manual operation of the relays
See from 4.3
Display of the alarm relays status
Manual operation of the relays
See from 4.3
Display of the status of actual alarms
See point 4.2
Reading and reset of errors
See from point 4.1
Reading and change of the relay, measuring point
and system parameters (security-relevant)
See from 4.8
Display
Parameters
Data Logger
Maintenance
Information
Sensor Readings
Signal Relays
Status
Alarm Relays
Status
Stage Status
Sy󰀬em Errors
Parameters

Intec Controls MSR PolyGard 2 DGC6 Specifications

General

Brand	Intec Controls
Model	MSR PolyGard 2 DGC6
Category	Controller
Language	English