Intec Controls MSR PolyGard 2 DGC6 - Page 14

INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com
Specifications subject to change without notice. | GAGC06_E_0516 | USA 200303 | Page 14 of 41
DGC6 – UserManual
Symbol Description Default Function
DX Measured value
Measured value from bus sensor with SP address with X = 1 - 96
AX Measured value
Measured value from analog sensor at analog input with AX = 1 - 32
CO Gas type
See 4.7.3
ppm Gas unit
See 4.7.3
A Average value
Arithmetic average (30 measured values within the time unit)
C Current value
Current value of gas concentration
S! Alarm
SP has triggered an alarm
# Maint. info
Device has exceeded maintenance date
? CongError
SP conguration not compatible
Error Fault SP
Communication error, or signal out of the measuring range
Locked SP locked
SP was temporarily locked by the operator.
The information CongError has priority to maintenance information.
Alarm information is always displayed with “!”, even if CongError or maintenance information are active.