Intec Controls MSR PolyGard 2 DGC6 - Page 3

INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com
Specifications subject to change without notice. | GAGC06_E_0516 | USA 200303 | Page 3 of 41
DGC6 – UserManual
4.8.3 Menu SP Parameters .........................................................................................................................28
4.8.3.1 Activate – Deactivate SP .............................................................................................................. 29
4.8.3.2 Lock or Unlock SP ........................................................................................................................ 29
4.8.3.3 Selection Gas Type with Unit ....................................................................................................... 30
4.8.3.4 Measuring Range Denition .........................................................................................................32
4.8.3.5 Stage Setpoint / Hysteresis ..........................................................................................................33
4.8.3.6 Delay for Alarm ON and/or OFF for Current Value Evaluation ..................................................... 33
4.8.3.7 Average Overlay (VDI 2053 Functionality) ...................................................................................33
4.8.3.8 Latching Mode Assigned to Alarm ................................................................................................33
4.8.3.9 SP Fault Assigned to Alarm ..........................................................................................................34
4.8.3.10 Alarm Assigned to Alarm Relay .................................................................................................. 34
4.8.3.11 SP Signal Assigned to Analog Output ........................................................................................ 34
4.8.4 Menu System Setup ...........................................................................................................................35
4.8.4.1 System Information ......................................................................................................................35
4.8.4.2 Service Interval ............................................................................................................................36
4.8.4.3 Average Function ......................................................................................................................... 36
4.8.4.4 Power On Time ............................................................................................................................ 36
4.8.4.5 Collective Fault Message Error Time ...........................................................................................36
4.8.4.6 Fault Activation by External DI .....................................................................................................36
4.8.4.7 GC Address ..................................................................................................................................36
4.8.4.8 Analog Output ..............................................................................................................................37
4.8.4.9 Relay Multiplication ......................................................................................................................37
4.8.5 Test Function of the Alarm and Signal Relays ....................................................................................39
4.8.6 Test Function of the Analog Outputs ...................................................................................................40
5 Notes and General Information ....................................................................................................................41
5.1 Intended Product Application ..................................................................................................................... 41
5.2 Installer’s Responsibilities .........................................................................................................................41
5.3 Maintenance ..............................................................................................................................................41
5.4 Limited Warranty ....................................................................................................................................... 41