14
Initial Setup
Initial Setup with Auto Start-up Wizard
Starting up: When you press Í, "Now Initializing..." is
displayed on the display. After this, when "Now
Initializing..." goes out, you can start operating the unit.
Wi-Fi connection settings
When you first turn the power on, the Network Setup
display is displayed automatically, allowing you to easily
make Wi-Fi connection settings.
To set, select the item with the cursors on the remote
controller and press Enter to confirm.
0 To return to the previous display, press Return.
1. Press Enter when "Network Setup" is displayed.
2. To make Wi-Fi settings, select "Wi-Fi". If you have
connected with an ethernet cable, select "Wired(Exit)"
with Up/Down on the remote controller and press Enter.
3. If you selected "Wi-Fi", select the setting method with Up/
Down on the remote controller and press Enter.
To Next Page
Loading...
Need help?
General
