10
Step2: Connect an external device
1. DIGITAL IN connection
Connect an external device with a digital optical cable or
digital coaxial cable. Note that this unit is equipped with an
"Opt1Wkup feature" so that when play starts on an external
device connected to the OPTICAL 1 (GAME) terminal, this
unit comes on and the INPUT SELECTOR automatically
changes.
0 The default setting for "Opt1Wkup feature" is "Off". To
enable this function, please press Setup on the remote
controller, and set "3. Hardware" - "Opt1Wkup". (P34)
0 The Opt1Wkup feature does not work when the unit is in
the mode for controlling ZONE 2 (P28).
0 Only PCM audio is supported for input through the
DIGITAL IN OPTICAL/COAXIAL jacks. Set the audio
output on the external device to output PCM.
> Before Start > Part Names >Install > Initial Setup > Playback
Supplementary information | Advanced Setup | Others
To Next Page
Loading...
Need help?
General
