6
Rear Panel
1. DIGITAL IN OPTICAL/COAXIAL jacks: Input digital audio signals from an external device
with a digital optical cable or digital coaxial cable.
2. REMOTE CONTROL jack: An Onkyo product with RI jack can be connected and
synchronized with this unit (P11).
3. USB jack: A USB storage device is connected so that music files stored in it can be
played. You can also supply power (maximum 5 V/1 A) to USB devices with a USB cable.
4. ETHERNET jack: Connect to the network with an Ethernet cable.
5. Wireless antenna: Raise for Wi-Fi connection or when using a BLUETOOTH wireless
technology enabled device. Adjust their angles according to the connection status.
6. IR IN/OUT jacks: Connected to the multi-room remote control kit. (*)
7. 12V TRIGGER OUT A/B/C jacks: Allows you to connect a device with 12V trigger input
jack to enable link operation between the device and the unit (P36, 37, 39). (*)
8. RS232 port: For connection to the home control system. (*)
(*)Special devices or cable connections are necessary to use the control functions 6 to 8.
Contact the specialized stores for more information.
9. AC INLET: Connect the supplied power cord.
10.
GND terminal: The ground wire of the turntable is connected.
11.
FM 75Ω/AM ANTENNA terminals: Connect the supplied FM indoor antenna and AM
indoor antenna.
12.
LINE IN jacks: Input audio signals from an external device with an analog audio cable.
13.
LINE OUT jacks: Connect a recording device, such as a cassette tape deck. Connect to
the LINE IN jacks on the recording device using analog audio cable.
14.
PRE OUT jacks: Connect a power amplifier.
15.
SUBWOOFER jack: Connect a subwoofer with built-in amplifier to amplify bass output.
To Next Page
Loading...
