Integra DTR-5.9 - Zone 2 out Settings

95
Zone 2 —Continued
If you’ve connected your Zone 2 speakers to an amp
with no volume control, set the Zone 2 Out setting, to
Variable so that you can set the zone’s volume, balance,
and tone on the AV receiver.
Note:
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow but-
tons.
Zone 2 Out Settings
1
Press the [Receiver] Remote
Mode button, followed by the
[Setup] button.
The main menu appears onscreen.
2
Use the Up and Down [ ]/[ ]
buttons to select “7. Hardware
Setup,” and then press [Enter].
The Hardware Setup menu appears.
Setup
Receiver
Zone2
Enter
Input
Selector
3
Use the Up and Down [ ]/[ ]
buttons to select “2. Zone 2,” and
then press [Enter].
The Zone 2 screen appears.
4
Use the Up and Down [ ]/[ ]
buttons to select “Zone 2 Out,”
and use the Left and Right
[ ]/[ ] buttons to select:
Fixed: The Zone 2 volume must be
set on the amp in that zone.
Variable: The Zone 2 volume can be
set on the AV receiver.
5
Press the [Setup] button.
Setup closes.
7–2. Zone2
Powered Zone2 Not Act
Zone2 Out Fixed
DTR-5.9En.book Page 95 Tuesday, April 15, 2008 9:53 AM