Integra DTR-8.8 - Powered Zone 2 Setting

126
Zone 2 and Zone 3 —Continued
If you’ve connected your Zone 2 speakers to the AV
receiver, as explained in “Connecting Your Zone 2 Speak-
ers Directly to the AV receiver” on page 124, you must set
the Powered Zone 2 setting to Act (Activated).
Notes:
• When Act is selected and Zone 2 turned on, the Zone 2
speakers connected to the ZONE 2 L/R speaker termi-
nals output sound, but the surround back speakers con-
nected to the SURR BACK L/R speaker terminals do
not. When Act is selected and Zone 2 turned off, the
surround back speakers output sound as normal.
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow but-
tons.
Powered Zone 2 Setting
1
Press the [Receiver] Remote
Mode button, followed by the
[Setup] button.
The main menu appears onscreen.
2
Use the Up and Down [ ]/[ ]
buttons to select “7. Hardware
Setup,” and then press [Enter].
The Hardware Setup menu appears.
+
-
On Standby
TV
Input
TV CH
TV VOL
--
/
---
10 11 12
D.TUN
+10
0
Clear
123
456
789
Input Selector
VCR / DVR CBL / SAT
DVD
Tape
Tuner
CD
Phono Net/USB
Game / TV
Macro
123
VCRDVD
CDR/MD/Dock
CD
Zone 2
Remote Mode
Dimmer
Tape/AMP
Sleep
Receiver TV
Net/USB
Cable
VOL
CH
Disc
Album
+
-
Enter
T
o
p
M
e
n
u
M
e
n
u
Display Muting
E
x
i
t
G
u
i
d
e
Prev
CH
R
e
t
u
r
n
S
e
t
u
p
Playlist
RandomRec
SAT
Zone 3
AUX 1 AUX 2
Setup
Receiver
Enter
Receiver
S
e
t
u
p
Enter
Enter
3
Use the Up and Down [ ]/[ ]
buttons to select “2. Zone 2/
Zone 3,” and then press [Enter].
The Zone 2/Zone 3 screen appears.
4
Use the Up and Down [ ]/[ ]
buttons to select “Powered
Zone 2,” and use the Left and
Right [ ]/[ ] buttons to select:
Not Act: ZONE 2 L/R speaker termi-
nals not activated (Powered
Zone 2 disabled).
Act: ZONE 2 L/R speaker termi-
nals activated (Powered Zone
2 enabled).
5
Press the [Setup] button.
Setup closes.
Enter
Enter
7-2.Zone2/Zone3
Powered Zone2 Not Act
Zone2 Out Fixed
Zone3 Out Fixed
Enter
Enter
S
e
t
u
p
DTR-8.8En.book Page 126 Friday, February 15, 2008 1:17 PM