Eclipse Additional Information Page 101
EndPos: End position of the curve.
CorrelationStartPos: Start of the correlation start pos.
MeasureType: Type of the measure. (ABR15/30, MMN,ALB.....)
WhatCurveContains: Is curve standalone, or is it the rare or frequent curve to a
MMN measure?
RarePointer: Curve ID to the RareCurve
FrequentPointer: Curve ID to the FrequentCurve
HeadSet: Headset type
NumberOfStoredSamples: Number of samples stored in memory.
CurveSelected: Is curve selected
SingleCurve: Single curve mode
STSIntensities: Intensity used for STS
StimuliTypeIsMerged: Stimulus type is merged
StimuliFreqIsMerged: Stimuli frequency is merged
MaskingIsMerged: Masking is merged
InputAttenuatorIsMerged: Attenuator value is merged
TestName: Name of used protocol
PatientID: Patient ID
TextForJewettX: Text used for jewett X
TextForJewettY: Text used for jewett Y
TextForJewettZ: Text used for jewett Z
NormAreaInSingleCurve: Show norm area in single mode
NumberOfWantedMeasurements: Number of wanted measurements
Reserved: Reserved for future use.
Reserved: Reserved for future use.
Reserved: Reserved for future use.
QualityValues: FMP values (350 values)
QualityResidualNoiseValues: Residual noise values (350 values)
QualityType: Type of quality calculations
VSymbolForRateStudy: Type of symbol for jewett V in rate study mode.
VEMPPartner: ID of VEMP partner curve
RMSPrestimulusVEMP: RMS value, prestimulus in VEMP mode
VisibleCurve: Is curve visible
AreaModeECochG: Type of area mode in ECochG
RefPointsECochG: Number of ref points for ECochG
EMGScalingOff: EMG scaling is off (VEMP measurement)
EMGValues: EMG values (500 values)
EMGUpperLimit: Upper limit for EMG
QualityTargetType: Type of quality type
QualityTargetString: Quality target string
QualityTarget: Level of quality target
ResidualNoiseTarget: Level of residual noise target
SplitScreen: Split screen on/off
Summed: Curve is summed
StimulusName: Name of stimulus as a string
APAmplitudeModeECochG: Type of amplitude mode, in ECochG
InputHighPass: Hardware high pass filter used
InputLowPass: Hardware low pass filter used
MaskingOffset: Offset of masking level
RejectionLevel: Rejection level
YPosACurve: Position of A curve
YPosBCurve: Position of B curve
CEChirpType: Type of CE chirp used
ShowStimulusRate: Show stimulus rate next to the curve
ShowStimulusFrequency: Show stimulus frequency next to the curve
Reserved: Reserved for future use.
Samples: Sampled values for IPSI A&B curve and A&B curve for Contra.
Total number of samples are NumberOfSamples * 4
To Next Page
Loading...
