Eclipse Additional Information Page 54
This option carries the potential for the operator to misinterpret the curve. It is important for the operator to note the dis-
play scale being used and to estimate the size of any response. Responses that are, in voltage terms, uncharacteristi-
cally small or large should be correctly identified as such and not mistaken for genuine responses.
Show EEG too low warning causes a warning to appear below the EEG window when the EEG is too low.
E.g when electrode are short circuited.
Invert VEMP on screen to change the display of the P1 and N1 polarity in accordance to user preference.
Please refer to the VEMP chapter for more information.
Baseline In order to ease the visual evaluation of the curves you can tick off Baseline. Baseline is a horizon-
tal line through the waveform at 0,0µV.
Draw intensity handle at baseline If you find it is a problem that the handle is placed far away from the
curve deactivate the draw intensity handle at baseline, and the handle will follow the curve when you change
the display of the vertical axis.
Show response confidence & residual noise bars will activate the display of the response confidence bar
& residual noise bar (is by default activated).
Show all Contra curves enables the display of all contra curves by default.
Show all A&B curves enables the display of the all A&B curves (rarefaction and condensation) when press-
ing on the Show A&B curve.
Green latency area (normally grey) changes the color of the latency area.
To Next Page
Loading...
Need help?
General
