Interlogix NS3552-8P-2S-V2 User Manual

Chapter 4: Web configuration
174 NS3552-8P-2S-V2 User Manual
3. Create a QoS profile that associates a service level and a classifier.
4. Apply a QoS profile to a port(s).
Port policing
The QoS Ingress Port Policers page permits configuration of the policer settings for all
switch ports.
The page includes the following fields:
Object Description
Port The port number for which the configuration below applies.
Enable Controls whether the policer is enabled on this switch port.
Rate Controls the rate for the policer. The default value is 500. This value is
restricted to 100-1000000 when the Unit is kbps or fps, and it is restricted to
1-3300 when the Unit is Mbps or kfps.
Unit Controls the unit of measure for the policer rate as kbps, Mbps, fps, or
kfps. The default value is kbps.
Flow Control If flow control is enabled and the port is in flow control mode, then pause
frames are sent instead of discarding frames.
Buttons
• Click Save to save changes.
• Click Reset to undo any changes made locally and revert to previously saved
values.

Interlogix NS3552-8P-2S-V2 Specifications

General

Brand	Interlogix
Model	NS3552-8P-2S-V2
Category	Switch
Language	English