Interlogix NS3552-8P-2S-V2 - Page 192

Chapter 4: Web configuration
190 NS3552-8P-2S-V2 User Manual
Object Description
IPv6: The QCE will match only IPV6 frames.
Action Indicates the classification action taken on ingress frame if parameters
configured are matched with the frame's content. Action fields are as follows:
Class: Classified QoS class. If a frame matches the QCE it will be put in the
queue.
DPL: Drop Precedence Level. If a frame matches the QCE then the DP level
will be set to the value shown under the DPL column.
DSCP: If a frame matches the QCE then DSCP will be classified with the
value shown under DSCP column.
Conflict Displays the conflict status of QCL entries when hardware resources are
shared by multiple applications. It may happen that resources required to
add a QCE may not be available, in which case it shows conflict status as
Yes, otherwise it is always No.
Conflict can be resolved by releasing the hardware resources required to
add the QCL entry by clicking the Resolve Conflict button.
Buttons
• Select the QCL status from the Combined drop-down list.
• Select the Auto-refresh check box to refresh the page automatically. Automatic
refresh occurs every three seconds.
• Click Resolve Conflict to release the resources required to add the QCL entry
when the conflict status for any QCL entry is Yes.
• Click Refresh to refresh the page.
Queue policing
Configure the queue policer settings for all switch ports in the QoS Ingress Queue
Policers page.