Chapter 4: Web configuration
NS3552-8P-2S-V2 User Manual 191
The page includes the following fields:
Object Description
Port The port number for which the configuration below applies.
Enable (E) Enable or disable the queue policer for this switch port.
Rate Controls the rate for the queue policer. This value is restricted to 25-
13128147 when "Unit" is kbps, and 1-13128 when "Unit" is Mbps. The rate is
internally rounded up to the nearest value supported by the queue policer.
This field is only shown if at least one of the queue policers are enabled.
Unit Controls the unit of measure for the queue policer rate as kbps or Mbps.
This field is only shown if at least one of the queue policers are enabled.
Buttons
• Click Save to save changes.
• Click Reset to undo any changes made locally and revert to previously saved
values.
Storm control configuration
Storm control for the switch is configured on the Storm Control Configuration page.
There is a unicast storm rate control, multicast storm rate control, and a broadcast
storm rate control. These only affect flooded frames (i.e., frames with a (VLAN ID,
DMAC) pair not present on the MAC Address table).
The configuration indicates the permitted packet rate for unicast, multicast, or
broadcast traffic across the switch.
To Next Page
Loading...
