Interlogix NS3552-8P-2S-V2 - Page 373

Chapter 6: Command line mode
NS3552-8P-2S-V2 User Manual 371
<alarm_id> : Alarm ID (1-65535).
<interval> : Sampling interval (1-2147483647) (default: 30).
<alarm_vairable> : The MIB OID that need to be referenced.
.1.3.6.1.2.1.2.2.1.10.xxx – ifInOctets
.1.3.6.1.2.1.2.2.1.11.xxx – ifInUcastPkts
.1.3.6.1.2.1.2.2.1.12.xxx – ifInNUcastPkts
.1.3.6.1.2.1.2.2.1.13.xxx – ifInDiscards
.1.3.6.1.2.1.2.2.1.14.xxx – ifInErrors
.1.3.6.1.2.1.2.2.1.15.xxx – ifInUnkownProtos
.1.3.6.1.2.1.2.2.1.16.xxx – ifOutOctets
.1.3.6.1.2.1.2.2.1.17.xxx – ifOutUcastPkts
.1.3.6.1.2.1.2.2.1.18.xxx – ifOutNUcastPkts
.1.3.6.1.2.1.2.2.1.19.xxx – ifOutDiscards
.1.3.6.1.2.1.2.2.1.20.xxx – ifOutErrors
.1.3.6.1.2.1.2.2.1.21.xxx – ifOutQLen
"xxx" means the interface identified by a particular value of this
index is the same interface as identified by the same value of
OID 'ifIndex'.
absolute : Get the sample directly.
delta : Calculate the difference between samples (default).
<rising_threshold> : Rising threshold value (-2147483648–2147483647).
<rising_event_index> : Rising event index (1-65535).
<falling_threshold> : Falling threshold value (-2147483648–2147483647).
<falling_event_index>: Falling event index (1-65535).
rising : Trigger alarm when the first value is larger than the rising
threshold.
falling : Trigger alarm when the first value is less than the falling threshold.
both : Trigger alarm when the first value is larger than the rising
threshold or less than the falling threshold (default)
Security Switch RMON Alarm Delete
Description:
Delete RMON Alarm entry. The entry index key is <alarm_id>.
Syntax:
Security Switch RMON Alarm Delete <alarm_id>
Parameters:
<alarm_id>: Alarm ID (1-65535).
Security Switch RMON Alarm Lookup
Description:
Show RMON Alarm entries.
Syntax:
Security Switch RMON Alarm Lookup [<alarm_id>]
Parameters:
<alarm_id>: Alarm ID (1-65535).