Interlogix NS3552-8P-2S-V2 - Page 415

Chapter 6: Command line mode
NS3552-8P-2S-V2 User Manual 413
Default Setting:
2
Example:
Set LLDP reinit delay value in 3
NS3552
-8P-2S-V2:/>lldp reinit 3
LLDP Statistics
Description:
Show LLDP Statistics.
Syntax:
LLDP Statistics [<port_list>] [clear]
Parameters:
<port_list>: Port list or 'all', default: All ports
clear : Clear LLDP statistics
Example:
Show LLDP Statistics of port 1
NS3552
-8P-2S-V2:/>
lldp statistics 1
LLDP global counters
Neighbor entries was
last changed at - (18819 sec. ago).
Total Neighbors Entries Added 0.
Total Neighbors Entries Deleted 0.
Total Neighbors Entries Dropped 0.
Total Neighbors Entries Aged Out 0.
LLDP local counters
Rx Tx Rx Rx Rx TLV Rx TLV Rx TLV
Port Frames Frames Errors Discards Errors Unknown Organz.
Aged
----
------ ------ ------ -------- ------ ------- ------- -----
1 0 0 0 0 0 0 0 0
LLDP Info
Description:
Show LLDP neighbor device information.
Syntax:
LLDP Info [<port_list>]
Parameters:
<port_list>: Port list or 'all', default: All ports