Interlogix NS3552-8P-2S-V2 - Page 430

Chapter 6: Command line mode
428 NS3552-8P-2S-V2 User Manual
MEP aps config [<inst>] [<prio>] [uni|multi] [laps|raps] [<octet>] [enable|disable]
Parameters:
<inst> : Instance number
<prio> : OAM PDU priority
uni|multi : Destination address is unicast or multicast
laps|raps : Selection of Linear or Ring APS type
<octet> : The last octet in RAPS multicast MAC
enable|disable: enable/disable
MEP Client Configuration
Description:
MEP Client configuration
'domport|domevc' is the client domain - must be EVC
'level' is the client MEG level - the contained level in the AIS and LCK frames
'cflow' is the client flow instance - up to 10 possible client flows (EVC).
Syntax:
MEP client config [<inst>] [domport|domevc] [<level>] [<cflow>] [<cflow>] [<cflow>]
[<cflow>] [<cflow>] [<cflow>] [<cflow>] [<cflow>] [<cflow>] [<cflow>]
Parameters:
<inst> : Instance number
domport|domevc: Flow domain
<level> : MEP level (0-7)
<cflow> : Client flow instance number (EVC)
MEP AIS Configuration
Description:
MEP AIS configuration
'prio' is the priority (PCP) of transmitted AIS frame
'1s|1m' is the number of AIS frame pr. second
'set|clear' is set or clear of protection usability. If set, the first three AIS frames are
transmitted as fast as possible - this gives protection reliability in the path end-
point.
Syntax:
MEP ais config [<inst>] [<prio>] [1s|1m] [set|clear] [enable|disable]
Parameters:
<inst> : Instance number
<prio> : OAM PDU priority
1s|1m : Transmit period for AIS
1s - to send OAM Frames in the rate of 1 per second
1m - to send OAM frames in the rate of 1 per minute
set|clear : Protection usability set/clear
enable|disable: enable/disable
MEP LCK Configuration
Description:
MEP LCK configuration
'prio' is the priority (PCP) of transmitted AIS frame
'1s|1m' is the number of AIS frame pr. second.