Interlogix NS3552-8P-2S-V2 User Manual

Chapter 6: Command line mode
NS3552-8P-2S-V2 User Manual 429
Syntax:
MEP lck config [<inst>] [<prio>] [1s|1m] [enable|disable]
Parameters:
<inst> : Instance number
<prio> : OAM PDU priority
1s|1m : Transmit period for LCK
1s - to send OAM Frames in the rate of 1 per second
1m - to send OAM frames in the rate of 1 per minute
enable|disable: enable/disable
MEP Link Trace Configuration
Description:
MEP Link Trace configuration
'prio' is the priority (PCP) of transmitted LTM frame
'mac_addr' is the unicast MAC of target MEP/MIP
'mep' is the peer MEP-ID of target MEP - only used if 'mac_addr is 'all zero'
'tll' is the TLL in the transmitted LTM.
Syntax:
MEP lt config [<inst>] [<prio>] [<mac_addr>] [<mep>] [<ttl>] [enable|disable]
Parameters:
<inst> : Instance number
<prio> : OAM PDU priority
<mac_addr> : MAC address ('xx-xx-xx-xx-xx-xx' or 'xx.xx.xx.xx.xx.xx' or
'xxxxxxxxxxxx', x is a hexadecimal digit)
<mep> : This MEP id (0-0x1FFF)
<ttl> : LT - Time To Live
enable|disable: enable/disable
MEP Loop Back Configuration
Description:
MEP Loop Back configuration
'set|clear' is set or clear of DEI of transmitted LBM frame
'prio' is the priority (PCP) of transmitted LBM frame
'uni|multi' is selecting uni-cast or multi-cast transmission of LBM frame
'mac_addr' is the unicast MAC of target MEP/MIP
'mep' is the peer MEP-ID of target MEP - only used if 'mac_addr is 'all zero'
'tosend' is the number of LBM to send
'size' is the size of the LBM data field
'gap' is the gap between LBM.
Syntax:
MEP lb config [<inst>] [set|clear] [<prio>] [uni|multi] [<mac_addr>] [<mep>]
[<tosend>] [<size>] [<gap>] [enable|disable]
Parameters:
<inst> : Instance number
set|clear : OAM DEI set/clear
<prio> : OAM PDU priority
uni|multi : Destination address is unicast or multicast
<mac_addr> : MAC address ('xx-xx-xx-xx-xx-xx' or 'xx.xx.xx.xx.xx.xx' or

Interlogix NS3552-8P-2S-V2 Specifications

General

Brand	Interlogix
Model	NS3552-8P-2S-V2
Category	Switch
Language	English