Interlogix NS3552-8P-2S-V2 User Manual

Chapter 6: Command line mode
430 NS3552-8P-2S-V2 User Manual
'xxxxxxxxxxxx', x is a hexadecimal digit)
<mep> : This MEP id (0-0x1FFF)
<tosend> : Number of LBM to send
<size> : Size of LBM data field in bytes (max 1400)
<gap> : Gap between LBM to send in 10ms. (max 100 - '0' is as fast as
possible)
enable|disable: enable/disable
MEP Delay Measurement Configuration
Description:
MEP Delay Measurement configuration
'prio' is the priority (PCP) of transmitted DM frame
'uni|multi' is selecting uni-cast or multi-cast transmission of DM frame
'mep' is the peer MEP-ID of target MEP - only used if 'uni'
'oneway|twoway' is selecting one-way (1DM) or two-way (DMM) DM
'std|prop' is selecting standadized or proprietary DM. the latest is using off-
standard follow-up message carrying the exact HW transmit timestamp
'rdtrp|flow' is selecting round-trip or flow delay calculation. Round-trip is not using
the far-end timestamps to calculate the far-end residence time
'gap' Gap between transmitting 1DM/DMM PDU - in 10 ms.
'count' number of frames used for average calculation on the latest 'count' frames
received
'us|ns' calculation results are shown in micro or nano seconds
'keep|reset' the action in case of total delay counter overflow - either 'keep' all
results or 'reset' all results
'd2ford1' this is selecting to used two-way DMM for calculate one-way delay.
Syntax:
MEP dm config [<inst>] [<prio>] [uni|multi] [<mep>] [oneway|twoway] [std|prop]
[rdtrp|flow] [<gap>] [<count>] [us|ns] [keep|reset] [d2ford1] [enable|disable]
Parameters:
<inst> : Instance number
<prio> : OAM PDU priority
uni|multi : Destination address is unicast or multicast
<mep> : This MEP id (0-0x1FFF)
oneway|twoway : DM is one-way or two-way
std|prop : Standard or Vitesse proprietary way(w/ follow-up packets) to send
DM
rdtrp|flow : 2/4 timestamps selection
<gap> : Gap between 1DM/DMM to send in 10ms(10-65535).
<count> : The number of last records to calculate(10 - 2000)
us|ns : Time resolution
keep|reset : The action to counter when overflow happens
d2ford1 : Enable to use DMM/DMR packets to calculate one-way DM
enable|disable: enable/disable
MEP Test Signal Configuration
Description:
MEP Test Signal configuration
'set|clear' is set or clear of DEI of transmitted LBM frame

Interlogix NS3552-8P-2S-V2 Specifications

General

Brand	Interlogix
Model	NS3552-8P-2S-V2
Category	Switch
Language	English