Interlogix NS3552-8P-2S-V2 User Manual

Chapter 6: Command line mode
442 NS3552-8P-2S-V2 User Manual
QoS DSCP Translation
Description:
Set or show global ingress DSCP translation table.
If port DSCP translation is enabled, translation table is used to translate incoming
frames DSCP value and translated value is used to map QoS class and DP level.
Syntax:
QoS DSCP Translation [<dscp_list>] [<trans_dscp>]
Parameters:
<dscp_list> : DSCP (0-63, BE, CS1-CS7, EF or AF11-AF43) list or 'all'
(default: Show DSCP translation table)
<trans_dscp>: Translated DSCP: 0-63, BE, CS1-CS7, EF or AF11-AF43
QoS DSCP Trust
Description:
Set or show trusted DSCP value which is used for QoS classification.
The DSCP value to be checked for trust is either translated value ifDSCP
translation is enabled for the ingress port or incoming frame DSCPvalue if
translation is disabled for the port. Trusted DSCP value is onlyused for QoS
classification.
Syntax:
QoS DSCP Trust [<dscp_list>] [enable|disable]
Parameters:
<dscp_list>: DSCP (0-63, BE, CS1-CS7, EF or AF11-AF43) list or 'all'
enable : Set DSCP as trusted DSCP
disable : Set DSCP as un-trusted DSCP
(default: Show DSCP Trust status)
Default Setting:
disable
QoS DSCP Classification Mode
Description:
Set or show DSCP ingress classification mode.
If port DSCP classification is 'selected', DSCP will be classified based on QoS
class and DP level only for DSCP value with classification mode 'enabled'. DSCP
may be translated DSCP if translation is enabled for the port.
Syntax:
QoS DSCP Classification Mode [<dscp_list>] [enable|disable]
Parameters:
<dscp_list>: DSCP (0-63, BE, CS1-CS7, EF or AF11-AF43) list or 'all'
enable : Enable DSCP ingress classification
disable : Disable DSCP ingress classification
(default: Show DSCP classification mode)
Default Setting:
disable
QoS DSCP EgressRemap
Description:
Set or show DSCP egress remap table. This table is used if the port egress

Interlogix NS3552-8P-2S-V2 Specifications

General

Brand	Interlogix
Model	NS3552-8P-2S-V2
Category	Switch
Language	English