Interlogix NS3552-8P-2S-V2 User Manual

Chapter 6: Command line mode
NS3552-8P-2S-V2 User Manual 443
remarking mode is 'remap' and the purpose is to map the DSCP and DP level to a
new DSCP value.
Syntax:
QoS DSCP EgressRemap [<dscp_list>] [<dpl_list>] [<dscp>]
Parameters:
<dscp_list>: DSCP (0-63, BE, CS1-CS7, EF or AF11-AF43) list or 'all'
<dpl_list> : DP level list or 'all', default: All DP levels (0-1)
<dscp> : Egress remapped DSCP: 0-63, BE, CS1-CS7, EF or AF11-AF43
QoS Storm Unicast
Description:
Set or show the unicast storm rate limiter.
Syntax:
QoS Storm Unicast [enable|disable] [<packet_rate>]
Parameters:
enable : Enable unicast storm control
disable : Disable unicast storm control
<packet_rate>: Rate in fps (1, 2, 4, ..., 512, 1k, 2k, 4k, ..., 32768k)
Default Setting:
disable
Example:
Enable unicast storm control in 2fps
NS3552
-8P-2S-V2:/> QoS Storm Unicast enable 2
QoS Storm Multicast
Description:
Set or show the multicast storm rate limiter.
Syntax:
QoS Storm Multicast [enable|disable] [<packet_rate>]
Parameters:
enable : Enable multicast storm control
disable : Disable multicast storm control
<packet_rate>: Rate in fps (1, 2, 4, ..., 512, 1k, 2k, 4k, ..., 32768k)
Default Setting:
disable
Example:
Enable multicast storm control in 2fps
NS3552
-8P-2S-V2:/>
QoS Storm multicast enable 2
QoS Storm Broadcast
Description:
Set or show the broadcast storm rate limiter. The limiter will only affect flooded
frames, i.e. frames with a (VLAN ID, DMAC) pair not present in the MAC Address
table.
Syntax:
QoS Storm Broadcast [enable|disable] [<packet_rate>]

Interlogix NS3552-8P-2S-V2 Specifications

General

Brand	Interlogix
Model	NS3552-8P-2S-V2
Category	Switch
Language	English