Interlogix NS3552-8P-2S-V2 User Manual

Chapter 4: Web configuration
NS3552-8P-2S-V2 User Manual 45
The current column is used to show the active IP configuration.
Object Description
DHCP Client Select this check box to enable the DHCP client. If DHCP fails and the
configured IP address is zero, DHCP will retry. If the DHCP server does not
respond in approximately 35 seconds and the configured IP address is non-
zero, DHCP stops and the configured IP settings will be used. The DHCP
client will announce the configured System Name as host name to provide
DNS lookup.
IP Address Provide the IP address of this switch in dotted decimal notation.
IP Mask Provide the IP mask of this switch dotted decimal notation.
IP Router Provide the IP address of the router in dotted decimal notation.
VLAN ID Provide the managed VLAN ID. The allowed range is 1 through 4095.
DNS Server Provide the IP address of the DNS Server in dotted decimal notation.
DNS Proxy When DNS proxy is enabled, DUT will relay DNS requests to the current
configured DNS server on DUT, and reply as a DNS resolver to the client
device on the network.
Buttons
• Click Save to save changes.
• Click Reset to undo any changes made locally and revert to previously saved
values.
• Click Renew to renew the DHCP Client. This button is only available if DHCP Client
is enabled.

Interlogix NS3552-8P-2S-V2 Specifications

General

Brand	Interlogix
Model	NS3552-8P-2S-V2
Category	Switch
Language	English