Chapter 4: Web configuration
NS3552-8P-2S-V2 User Manual 65
If the destination is running-config, the file will be applied to the switch configuration.
This can be done in two ways:
• Replace mode: The current configuration is fully replaced with the configuration in
the uploaded file.
• Merge mode: The uploaded file is merged into running-config.
If the file system is full (i.e., it contains the system files mentioned above plus two other
files), it is not possible to create new files unless an existing file is overwritten or
another is deleted first.
Configuration activate
The Activate Configuration page permits activation of the startup-config and default-
config files on the switch.
It is possible to activate any of the configuration files present on the switch, except for
running-config which represents the currently active configuration.
Select the file to activate and click Activate Configuration. This initiates the process of
completely replacing the existing configuration with that of the selected file.
To Next Page
Loading...
