Specifies the email address to which messages are sent when an alarm
occurs.
To define the TCP/IP parameters:
1. In the Network folder, click the TCP/IP tab to open its window.
2. Configure the NIC settings, including the NIC Type, IPv4 settings, IPv6
settings, MTU settings, and Multicast Address.
3. If the DHCP server is available, check DHCP.
4. If the DNS server settings are required for some applications (e.g., sending
email), you should configure the Preferred DNS Server or Alternate DNS
Server.
5. Click Save to save changes.
To define the port parameters:
1. In the Network folder, click the Port tab to open its window.
2. Set the HTTP port, RTSP port, HTTPS port and SDK port of the camera.
3. Click Save to save changes.
To define the DDNS parameters:
1. In the Network folder, click the DDNS tab to open its window.
2. Check Enable DDNS to enable this feature.
3. Select DDNS Type. Two options are available: DynDNS and IPServer.
• DynDNS: Enter the user name and password registered to the DynDNS
web site. The domain name is that of the DynDNS web site.
• ezDDNS: Enter the host name, it will automatically register it online.
• IPServer: Enter the address of the IP Server.